TAMIYA M1025 Rear Shock Mount Aluminium HM1030 by GPM  [HM1030]

Aluminium rear shock mount for the M1025 chassis

This aftermarket aluminium rear shock mount is designed and produced by GPM for the TAMIYA M1025 Hummer, supplied as a single 1pcs replacement. It is intended to replace the factory rear shock mount and deliver a firmer mounting point for rear dampers without altering the stock suspension geometry.

Using aluminium increases dimensional stability and resistance to wear compared with typical plastic mounts. The HM1030 is useful for routine repairs and modest tuning steps where a stiffer mounting point helps preserve shock alignment under heavier loads. Installation only requires standard hand tools; check reused hardware for damage before refitting.

Fitment tips: trial-fit the mount on your TAMIYA M1025 Hummer prior to permanent installation, torque fasteners to recommended levels to avoid thread damage, and verify wheel travel after fitting to confirm the original suspension range remains intact.