Tamiya Mini 4WD Gold Rail Guard M4WD-49/GO by 3Racing  [M4WD-49/GO]

Tamiya Mini 4WD Aluminum Rail Guard -Gold - 3RACING M4WD-49/GO
Price:
NZD$8.59
Brand:
3Racing
Model:
M4WD-49/GO
Condition:
Brand New
Write a review

M4WD-49/GO gold rail guard for Tamiya Mini 4WD

This aluminium rail guard is an aftermarket stabiliser made to fit Tamiya Mini 4WD bodies and chassis that accept add-on rails. The gold anodized surface enhances aesthetics and withstands light wear better than painted substitutes. The focus is on appearance and fit rather than claiming performance gains.

Compatibility is normally straightforward: the guard suits common Mini 4WD layouts but check the mounting hole spacing and rail thickness against Super-II, MS, MA, or other chassis types before fixing it in place. Small spacers or washers often help align slightly different hole patterns.

For collectors and display builds the consistent anodized finish keeps colour tones uniform and reduces visible scuffs. Consider this item a structural cosmetic upgrade rather than a tuning component.

Will this guard fit a Super-II chassis without drilling?

If the factory mounting holes line up, no drilling is needed. If spacing differs slightly, small washers or countersunk screws can help secure the guard without heavy modification.

What cleaner is safe for the anodized surface?

A mild detergent and soft cloth are sufficient. Avoid scouring pads and solvent-based cleaners which can remove the anodized sheen.

Can I use this as a mounting point for other accessories?

The guard adds modest structural support but is not engineered as a primary load-bearing part. Use it for light mounts and cosmetic attachments only.

Is the guard lightweight enough for 1/32 racers?

Aluminium keeps the weight low compared with steel, but the guard is a cosmetic accessory rather than a tuned weight-saving measure. Expect a small mass increase over plastic parts.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved