Tamiya Mini 4WD Multi-Roller Carbon Flat Plate for front rear side stays - M4WD-16 by 3Racing  [M4WD-16]

M4WD-16 carbon flat plate for Mini 4WD stay installs

The carbon multi-roller flat plate offers an aftermarket mounting option compatible with Tamiya Mini 4WD models. Its flat, single-piece layout delivers a rigid platform for mounting several roller arrangements on front, rear or side stays, appealing to hobbyists who tune or display Mini 4WD cars.

Design notes: keeping rollers in one plane lowers stacking complexity and helps control lateral travel without extra stay assemblies. Carbon parts are much stiffer than stock plastics and can influence handling on Super-II, MA, MS, AR, FM-A and VS style chassis, so confirm compatibility with your setup.

Installation considerations: check hole spacing and the length of fasteners for your stay posts, and add thin washers or spacers where needed to avoid point loads on bearings. Make sure each roller clears neighbouring parts when rotating.

Care and maintenance: carbon is durable but vulnerable to delamination if stressed; use correct torque on screws and inspect after use. Clean gently and avoid harsh solvents that could damage adhesives or finishes.