TAMIYA T3-01 DANCING RIDER Rear wheel stabiliser screw set T3050R/SM by GPM  [T3050R/SM]

Rear wheel stabiliser hardware

This stainless steel flat-head screw and flanged washer kit is an RC-scale replacement for the TAMIYA T3-01 DANCING RIDER rear wheel fixings. It tackles wheel rattle by widening the contact area and using rust-resistant stainless parts for consistent fitment over time.

The set contains two stainless steel flat-head screws 2.5x14 and two stainless flanged washers. The flanged washers offer a broader seating surface than stock, which helps reduce lateral play and keeps wheels aligned under load.

To install, remove the original rear screws, place the flanged washers on the hub, then secure with the 2.5x14 screws. Tighten to firm seating only; avoid over-tightening to prevent crushing plastic hubs. Suitable for original wheels and compatible optional wheels in hobby use.