TAMIYA T3-01 Steering Arms Aluminium T3054 by GPM  [T3054]

Price:
NZD$16.59
Brand:
GPM
Model:
T3054
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Aluminium steering arms tailored for T3-01

This aftermarket arm set is intended as a replacement for plastic steering arms on the TAMIYA T3-01 DANCING RIDER. The aluminium construction increases stiffness over stock parts, helping keep consistent wheel alignment during hard cornering.

Fitting is a straightforward swap: remove the front hubs and steering links, mount the new arms to the knuckles, then verify steering sweep and servo play. Use routine RC tools and confirm clearances before running.

From a setup perspective, the added rigidity reduces flex and delivers more predictable steering changes, making small tuning tweaks more apparent during test laps and club runs.

Are these compatible with all T3-01 variants?

They are made for the T3-01 DANCING RIDER geometry. Confirm your variant matches the mounting points before purchase.

Will fitment affect steering geometry?

The parts maintain the same mounting positions but reduce flex, which can alter perceived toe and transient response; re-check alignment after installation.

Any maintenance tips?

Regularly inspect mounting screws for looseness and check hubs for wear. Clean and inspect after offroad runs to prevent grit build up.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved