Tamiya T3-01 Wheel Hub 12mm Hex with 7mm Offset - T301-02 by 3Racing  [T301-02]

12mm Hex Adapter for T3-01

This adapter is built as an aftermarket wheel hub for the Tamiya T3-01 chassis, providing a 12mm hex mount and a 7mm offset to alter wheel stance. It is aimed at modest adjustments to track width and scrub radius for handling setup work.

Installation is aimed at hobbyists familiar with wheel swaps: remove the wheel and original hub, fit the 12mm hex adapter onto the existing axle or stub fitted to the T3-01, then secure with your current wheel nut or retention hardware. Always check clearance around suspension and bodywork after fitting the offset hub and verify wheel alignment and nut torque following a trial run.

Ideal for making incremental wheel placement changes to influence corner balance, reduce uneven tyre wear, or correct steering geometry. Treat this as an accessory part for tuning and inspect fitment and fastenings before each session.