Tamiya TA-01 Compatible Front Suspension Arms JR-TA110-RD (Red) by Jazrider  [JR-TA110-RD]

Price:
NZD$16.12
Brand:
JAZRIDER
Model:
JR-TA110-RD
Condition:
Brand New
Available in shop
Write a review

Lightweight anodized arms built for TA-01

These aluminum front suspension arms (model JR-TA110-RD) serve as an aftermarket replacement specifically for the Tamiya TA-01 chassis. Delivered in red anodize, the parts are intended as direct-fit RC-scale components that substitute the stock front arms on supported TA-01 vehicles without any chassis modification.

Install the units using the chassis' existing mounting points and conventional hardware when possible. While fitting, check ball studs, linkage clearances, and ensure symmetrical left/right positioning; verify steering sweep before you run the car. Only routine 1/10 scale hobby tools are required.

From a setup viewpoint, replacing molded plastic arms with aluminum alters the front-end stiffness and can affect steering feedback and transient response. Approach these arms as a tuning item: make measured adjustments to servo travel, tie-rod lengths, and roll center, then evaluate changes during test runs.

Yes. These arms are designed for direct fitment to standard TA-01 mounting points and do not require chassis modification.
Generally aluminum offers better long-term durability versus molded plastic, though impacts can still cause bending. Inspect parts after heavy use and replace if deformed.
Start with minor servo endpoint adjustments and small tie-rod length changes. Run progressive tests to observe steering sensitivity and tweak roll center as needed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved