Tamiya TA-01 Front Suspension Arm Upgrade JR-TA110-LB Light Blue Aluminum by Jazrider  [JR-TA110-LB]

Price:
NZD$16.12
Brand:
JAZRIDER
Model:
JR-TA110-LB
Condition:
Brand New
Available in shop
Write a review

TA-01 front arms in anodized light blue aluminum

The JR-TA110-LB front suspension arms upgrade the stock plastic components on the Tamiya TA-01 chassis to light blue anodized aluminium parts made for on-road RC applications. They are intended to raise rigidity at the front end and give a more consistent mounting surface for suspension linkages compared to factory plastic arms.

Fitting is straightforward for experienced TA-01 owners: remove the original arms, swap over hubs or bearings as needed, and refit the replacement arms using the existing mounting points and hardware. The geometry is matched to TA-01 specifications so no chassis alteration should be necessary when installed correctly.

Setup advice: aluminium arms influence steering feel and weight distribution, so check toe, camber and preload after installation and adjust progressively to dial in handling improvements.

Not usually. Transfer existing wheel hubs and bearings where they fit; only replace items that show wear or do not seat correctly with the new arms.
Aluminium arms are generally stiffer and resist long-term deformation better than plastic, which can improve service life under normal on-road use.
Yes. Because the arms alter front-end stiffness and geometry behaviour slightly, recheck toe, camber and suspension preload and make incremental adjustments while testing.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved