Tamiya TA-01 Rear Suspension Arms, Gun Metal Aluminum JR-TA111-GU by Jazrider  [JR-TA111-GU]

Price:
NZD$17.93
Brand:
JAZRIDER
Model:
JR-TA111-GU
Condition:
Brand New
Available in shop
Write a review

Gun metal aluminium rear arms for TA-01 chassis

These aluminum rear suspension arms provide a metal replacement for the TA-01 rear-arm mounting points on the Tamiya TA-01 chassis. The gun metal surface gives a distinct look while the aluminum material reduces flex compared with the original plastic arms.

The parts are specified for the Tamiya TA-01 only and are intended to interface with the chassis' original hinge pins and rear hub hardware. No other chassis compatibility is stated.

Fitment guidance: remove the stock rear hubs and arms as per your TA-01 maintenance procedure, transfer any reusable fixings, and install the aluminum arms in the same hinge-pin positions. Check that suspension articulation and wheel alignment are correct before final tightening, using conservative torque values suited to aluminium components.

Handling notes: aluminum rear arms alter the chassis' rear compliance and can affect traction and roll behavior. These arms are useful when experimenting with firmer rear geometry or seeking a steadier pivot point; adjust roll center and damping progressively to find the desired balance.

Aluminum reduces flex and resists deformation under load better than typical plastics, improving consistency under high cornering forces; however, aluminum can bend under impact differently than plastic and may require straightening or replacement after heavy crashes.
The finish provides visual protection and resists minor surface wear; routine inspection after running in wet or abrasive conditions is recommended to catch any corrosion or coating damage early.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved