Tamiya TA01/DF01 Compatible Black Aluminum Shaft JAZRIDER JR-TA100-BK with Joint Set  [JR-TA100-BK]

Tamiya TA01/DF01 Aluminum Main Drive Shaft w/Joint (Black) Set
Price:
NZD$14.30
Brand:
JAZRIDER
Model:
JR-TA100-BK
Condition:
Brand New
Available in warehouse
Write a review

Robust replacement shaft for TA01 and DF01 models

The JAZRIDER JR-TA100-BK black aluminium main drive shaft offers a practical swap-in upgrade for Tamiya TA01 and DF01 owners. It improves resistance to wear and delivers steadier power transfer on grass or hardpack surfaces.

Designed for Tamiya chassis

Built to align with the TA01 and DF01 drivetrain layout, this shaft is straightforward to fit and uses standard mounting locations. The stronger profile reduces slop between connected parts under load.

Why aluminium is a good choice

Aluminium combines lightness with good tensile strength, helping keep rotating mass low while resisting damage. The black finish gives a tidy look and extra protection against salt and moisture exposure.

Can I use this with hop-ups on my TA01?

Yes. The JR-TA100-BK is compatible with common TA01 and DF01 hop-up parts and maintains the correct geometry for most setups.

Any special care after wet runs?

Rinse and dry the shaft, then apply a light protective film of grease to prevent surface corrosion, especially after coastal or muddy sessions.

Will this reduce drivetrain noise?

Because it fits tighter and resists wear, it can reduce play that causes rattles, so some users notice quieter running after the swap.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved