Tamiya TA05 0 Degree Rear Hub Carrier Aluminium - TA05-16/0/LB by 3Racing  [TA05-16/0/LB]

Rear carrier for TA05 in 0 degree configuration

This aluminium rear hub carrier is supplied as a direct-fit replacement for the Tamiya TA05 chassis in a 0 degree layout. The part is machined from aluminium and finished in light blue anodize to replace plastic stock components where appropriate, resulting in consistent rear-end stiffness and repeatable wheel positioning.

Fitment depends on TA05-series mounting geometry and factory hardware; verify your chassis before installation. The carrier connects to the standard rear uprights and wheel hubs and keeps original axle and bearing interfaces, so it suits typical 1/10 scale TA05 touring setups.

Installation advice: use the original mounting screws where possible and apply correct torque for aluminium components to protect threads. When tuning, expect small setup adjustments to rear toe or camber after fitting. This product is for RC scale cars only and is not suitable for road vehicles.