Tamiya TA05-IFS Ball Bearing Upgrade Kit BS-M05/V1 by 3Racing  [BS-M05/V1]

Tamiya TA05-IFS Option Ball Bearing Set - 3RACING BS-M05/V1
Price:
NZD$21.28
Brand:
3Racing
Model:
BS-M05/V1
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Service and upgrade bearings for TA05-IFS

This ball bearing kit is prepared for use with the Tamiya TA05-IFS chassis and is listed under BS-M05/V1. The set supplies the bearings used in the TA05-IFS drivetrain and rotating assemblies to support maintenance and incremental handling refinement.

Installation priorities are correct seating, clean bearing races and unobstructed shaft rotation. Bearings from this kit are commonly fitted into wheel hubs, differential carriers and other rotating mounts on the TA05-IFS, so check each mounting point for proper alignment before final assembly.

Use this set to keep the chassis running smoothly rather than to change core geometry. Regular checks, appropriate lubrication and timely replacement of worn bearings will maintain predictable performance.

Will these bearings fit aftermarket TA05-IFS parts?

They are sized for the usual bearing locations on TA05-IFS parts; most aftermarket hubs and carriers that accept standard ball bearings will accept these, but always confirm dimensions before fitting.

Can I run these bearings without seals?

Open bearings reduce drag and are fine for clean indoor use, but sealed or lightly lubricated bearings are preferable for outdoor or dirty conditions to extend service life.

Any fitment tips to avoid damage during install?

Press bearings squarely into their seats, avoid hammering on the inner race, and clean mating surfaces to prevent premature wear or binding.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved