Tamiya TA07 Front Suspension Mounts Aluminium Upgrade - JR-TA704-BK by Jazrider  [JR-TA704-BK]

Tamiya 58636 TA07 Aluminum Front Suspension Mount Set (Black)
Price:
NZD$10.12
Brand:
JAZRIDER
Model:
JR-TA704-BK
Condition:
Brand New
Write a review

Front Mounts for TA07 Chassis

These front suspension mounts are made for the Tamiya TA07 platform and carry the model number JR-TA704-BK. Constructed from aluminium with a black finish, they serve as a direct swap or hop-up piece for the TA07 front mount locations.

Upgrading to aluminium increases stiffness relative to plastic parts, affecting steering precision, camber stability and the way loads move through the suspension. They are suitable when you want a sharper front feel or when replacing fatigued plastic mounts.

Fitting is straightforward for most hobbyists with standard RC tools. Check alignment and fastener selection before tightening, re-check suspension travel after installation, and apply thread-lock to steel screws where needed to keep components secure during use.

How much stronger are these than the stock plastic mounts?

Aluminium offers higher rigidity and better wear characteristics than typical plastics, which usually results in firmer steering feedback and reduced deformation under load, though actual improvement depends on setup and driving style.

Will the black finish chip with heavy use?

Cosmetic wear can appear over time where components contact other parts, but surface wear does not normally affect the structural performance of the aluminium mount.

Can I use these with aftermarket shock towers?

In most cases yes, but confirm hole spacing and stack heights to ensure the combined parts clear and align correctly with your steering and suspension geometry.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved