TAMIYA Thunder Shot Compatible Front C-Hub, Aluminum JR-TFD02-BK by Jazrider  [JR-TFD02-BK]

Tamiya Thunder shot/ Thunder Dragon/ Fire Dragon/ Terra Scorcher Aluminum Front C-Hub (Black)
Price:
NZD$19.20
Brand:
JAZRIDER
Model:
JR-TFD02-BK
Condition:
Brand New
Available in shop
Write a review

Heavy-Duty Front C-Hub for TAMIYA Buggies

A machined aluminum front C-hub intended as a durable replacement for TAMIYA Thunder shot, Thunder Dragon, Fire Dragon, and Terra Scorcher 1/10 models. The black anodized finish and metal construction give a stronger mounting point compared to stock plastic components.

By replacing the stock C-hub you gain reduced mount flex and improved retention of steering geometry under stress, which helps when restoring worn suspension assemblies. Confirm axle and bushing compatibility before final installation.

Fitment advice: preserve original bearings and fasteners if they remain in good condition, follow chassis torque specs to prevent fastener damage, and check that the uprights move freely through suspension travel. This is a hobby aftermarket item.

Will aluminum prevent future cracking seen on plastic hubs?

Aluminum reduces the chance of stress cracking at the pivot compared to plastic, but impacts and extreme loads can still bend or abrade metal over time. Regular inspection is advised.

Is the finish corrosion resistant for wet conditions?

The black finish helps resist surface corrosion, but rinsing and drying after wet use will extend service life. Check mating hardware for rust susceptibility.

How often should I inspect the hub after heavy use?

Inspect hubs after any hard impact and as part of routine maintenance every few runs. Look for loosened fasteners, axle play, and wear at contact points.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved