TAMIYA Thunder Shot Compatible Front Damper Stay, Red Anodized JR-TSD03-RD by Jazrider  [JR-TSD03-RD]

Tamiya Thunder Dragon/ Thunder Shot Aluminum Front Damper Stay (Red)
Price:
NZD$13.03
Brand:
JAZRIDER
Model:
JR-TSD03-RD
Condition:
Brand New
Available in shop
Write a review

Aluminum Front Damper Mount for TAMIYA Buggies

This replacement aluminum front damper stay fits TAMIYA Thunder Dragon and Thunder Shot models and replaces the stock plastic piece. The increased stiffness provides a firmer mounting surface, reducing movement at the attachment points under load and offering a consistent foundation for adjusting front suspension settings.

Installation is a simple swap: remove the original stay, move over any caps or spacers, and secure the new stay with the factory screws. Use the correct hex drivers, align components before fully tightening, and avoid excessive torque to protect the threads. Apply thread locker on steel fasteners only if it is compatible with the existing parts.

How it helps tuning: this part improves the repeatability of damper placement rather than changing suspension geometry. You should notice less variation during setup when changing springs or damping, but always check for clearance with shock towers and steering links after fitting.

The aluminum stay offers greater resistance to flex and impact than the original plastic, so it holds mount geometry more consistently under stress, though hard impacts can still transfer loads elsewhere in the chassis.
The red anodize is durable for normal use; clean with mild soap and water and avoid harsh abrasives to preserve the finish. Check threaded interfaces for corrosion periodically if used in wet conditions.
Inspect mounting screws for loosening and verify there is no contact with steering or shock hardware after initial test runs. Re-torque as needed following the first few outings.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved