Compatible with TAMIYA Thunder Shot/Thunder Dragon/Fire Dragon/Terra Scorcher Lower Suspension Arms (Aluminum) JR-TFD05-LB by Jazrider  [JR-TFD05-LB]

Tamiya Thunder shot/ Thunder Dragon/ Fire Dragon/ Terra Scorcher Aluminum Front/Rear Lower Suspension Arms (2pcs,Blue)
Price:
NZD$26.09
Brand:
JAZRIDER
Model:
JR-TFD05-LB
Condition:
Brand New
Available in shop
Write a review

Replacement aluminum lower links

The JR-TFD05-LB front and rear lower suspension arms are produced as a direct-fit aftermarket replacement for TAMIYA Thunder Shot, Thunder Dragon, Fire Dragon and Terra Scorcher buggies. Supplied in pairs, these aluminum arms are intended to replace the stock plastic pieces when a stiffer link is required for setup consistency and longevity.

Fitment is limited to the chassis models named above; use on other platforms is not covered. The blue finish aids inspection and makes it easier to spot wear after running sessions.

Fitment tip: these arms fit the same mounting points as the originals on compatible TAMIYA chassis and work with existing hub and suspension geometry. After fitting, cycle full suspension travel and check clearance around driveshafts and shock towers to avoid interference.

Setup impact: installing aluminum lower arms cuts down flex at the mounting points and can affect turn-in and mid-corner feel. Use incremental adjustments to shocks and alignment to restore balance rather than making large changes at once.

Specifications

  • Item: Front/Rear lower suspension arms, 2pcs
  • Material: Aluminum
  • Model Number: JR-TFD05-LB
  • Compatibility: TAMIYA Thunder Shot, Thunder Dragon, Fire Dragon, Terra Scorcher

JR-TFD05-LB arms provide a robust aluminum option for the listed TAMIYA Thunder-series buggies to reduce unwanted flex; always verify the arm layout on your chassis prior to competitive use.

They occupy the same mounting positions as the originals, so geometry remains nominally the same; however, the reduced material flex can alter effective behavior, so check toe and camber after installation.
Installation typically uses the same basic hobby tools as the original parts. Preserve any original pins or fasteners unless replacements are provided.
Start with modest increases in shock damping and recheck toe and camber; run a few test laps and make small iterative changes until the chassis balance feels right.
The listing indicates a blue anodized finish for these arms, which also helps with post-run inspection.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved