Tamiya TL-01/GF-01/WR-02 Rear Lower Suspension Arm Upgrade JR-TL103-BK by JAZRIDER  [JR-TL103-BK]

Tamiya TL-01/GF-01/WR-02 Aluminum Rear Lower Suspension Arm (Black)
Price:
NZD$17.51
Brand:
JAZRIDER
Model:
JR-TL103-BK
Condition:
Brand New
Available in shop
Write a review

Aftermarket aluminum lower arm for Tamiya chassis

Engineered as an aftermarket aluminum replacement, this rear lower suspension arm fits Tamiya TL-01, GF-01, and WR-02 chassis that share the same rear arm layout. The single-piece aluminum construction offers a metal option where direct-fit replacement is required.

Switching from molded plastic to aluminum alters the linkage stiffness and its wear profile, providing a more durable part under frequent use. The design assumes use of the chassis' original attachment points and commonly used fasteners for mounting.

In practical tuning, this arm is chosen to stabilise rear-end feedback and maintain consistent handling during repeated runs. Always check suspension travel and clearance after fitting to ensure there is no interference with nearby components.

Will the aluminum construction hold up better than stock?

Aluminum generally resists wear and impact better than many plastics, so you can expect improved longevity in high-stress or frequent-use scenarios compared with stock arms.

Is the arm a direct replacement or does it need modification?

This part is intended as a direct-fit aftermarket component for compatible Tamiya chassis. Perform a trial fit to confirm alignment and that existing fasteners secure the arm without modification.

What maintenance differences should I expect with aluminum?

Aluminum can require periodic inspection for burrs or thread wear but resists degradation from repeated loading better than many plastics. Keep an eye on pivot points and replace worn pins or bushings as needed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved