Tamiya Tracktor Truck Rear Wheel Upgrade Alloy 10-hole TRU091R by GPM  [TRU091R]

Tracktor Truck rear wheel set in alloy

This two-piece rear wheel set is built for the Tamiya Tracktor Truck platform, featuring a 10-hole bolt layout and aluminum alloy construction. Supplied as 2 pcs, the wheels are suitable as replacements or rear upgrades on Tracktor Truck chassis where the 10-hole fitment is required, for electric RC hobby use only.

The alloy design gives consistent stiffness and helps control dimensional change under load to reduce wheel runout. Fitting normally uses the original wheel hardware and hex adapters from the Tracktor Truck; always confirm hub spacing and bolt pattern before installation. Because these wheels change unsprung weight and balance, recheck alignment and use accepted RC wheel balancing methods after fitting.

Ideal when you want a more rigid rear wheel or to replace damaged plastic wheels. Verify fitment to your Tracktor Truck hubs and perform mounting and balancing checks before full use.