TAMIYA Tractor Truck (1850l) Rear Chassis Bracket TRU031 by GPM  [TRU031]

Tractor Truck (1850l) Alloy Rear Chassis Mount With Screws (#C19)-1pr set (5OL) - GPM TRU031
Price:
NZD$16.97
Brand:
GPM
Model:
TRU031
GTIN:
4894538202373
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Alloy rear chassis bracket for 1850l models

This alloy rear chassis bracket is a scale RC replacement intended for TAMIYA Tractor Truck 1850l variants, supplied as a 1pr set with mounting screws. It is designed to locate and secure the rear chassis section, helping preserve alignment and providing a stable attachment point during setup and routine repairs.

Installation is suitable for enthusiasts familiar with TAMIYA chassis: remove the existing rear mount, retain any hardware that can be reused, position the alloy bracket into the chassis mounting points, then fasten using the supplied screws. Confirm hole alignment prior to final torque to prevent cross-threading and to ensure correct chassis geometry.

Offered as an aftermarket hop-up, the bracket serves as a direct replacement or a simple material upgrade to change mounting stiffness; handle and fit as you would any RC-scale component.

Does this bracket replace the stock rear mount?

Yes, it is intended as a direct replacement for the stock rear mount on Tractor Truck 1850l models and comes as a 1pr with screws for fitment.

Are the supplied screws standard sizes?

The listing shows mounting screws are included with the set. Check existing chassis hardware and thread type before mixing with other fasteners.

How do I avoid misalignment during fitment?

Start screws by hand, ensure the mount sits flush, and tighten evenly in stages to keep the chassis geometry true while seating the bracket.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved