Tamiya Tractor Truck Servo Mount Aluminium 16pc kit TRU024X by GPM  [TRU024X]

TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X
Price:
NZD$28.97
Brand:
GPM
Model:
TRU024X
GTIN:
4894538274516
Condition:
Brand New
Write a review
alt="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X" title="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X"
alt="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X" title="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X"
alt="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X" title="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X"
alt="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X" title="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X"
alt="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X" title="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X"
alt="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X" title="TAMIYA TRACTOR TRUCK Aluminium Servo Mount -16pc set - GPM TRU024X"

Servo mounting solution for Tamiya Tractor Truck

This aluminium servo mount set is produced as an RC accessory to hold a servo firmly within Tamiya Tractor Truck assemblies, preventing movement under load and during setup changes.

The design emphasises reliable positioning and easy fitment so you can fine tune servo placement without modifying the stock chassis. Suitable for hobby-level RC installs and tuning procedures.

Packing includes

  • 3X10 Stainless Steel Flat Head Screw - 4pcs
  • 3X6 Stainless Steel Button Head Screw - 2pcs
  • 3X8 Stainless Steel Button Head Screw - 3pcs
  • 3MM Counter Sink - 4pcs

Specifications

  • Item: Tamiya Tractor Truck Aluminium Servo Mount 16pcs set
  • Material: Aluminium
  • Model Number: TRU024X
  • Compatibility: Tamiya Tractor Truck

Use this mount to secure servo alignment and reduce endplay during setup, and always re-check linkage geometry after installation to ensure smooth operation.

Is the hardware included sufficient for mounting?

Yes, the included screws and countersinks in the Packing includes list are intended to secure the servo plates to compatible mounting points.

Will this change my servo travel?

The mount itself does not alter servo travel but it can affect horn alignment; verify travel and endpoints after installation to confirm correct operation.

What material and finish does the mount use?

The plates are aluminium for a balance of strength and light weight. Check the Specifications list for material and model information.

Any recommended installation tips?

Progressively tighten screws, centre the servo before final tightening and confirm there is no binding at full travel to avoid damage.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved