TAMIYA TRF 415 Aluminium Suspension Mount 1D Ver 2 415-01/1D/V2 by 3Racing  [415-01/1D/V2]

Machined aluminium mount for the TRF 415

This option replaces the stock suspension mount on the TAMIYA TRF 415 chassis with a machined aluminium 1D Ver. 2 piece. It is built to deliver a stable mounting reference for the TRF 415 suspension without altering the chassis attachment layout.

Fitment is intended for users comfortable with basic RC maintenance: remove the factory mount and locate the aluminium unit on the same suspension attachment points. Use the original screws where they fit and check for correct alignment before final tightening to avoid restricting suspension travel. Additional parts are not included unless the seller lists them.

During setup, a metal mount will shift stiffness characteristics versus the original plastic part, which can influence how camber and roll centre respond under load. Use this part when you want a consistent baseline for shock and link adjustments on the TRF 415.

Routine care is minimal: look for burrs at mating faces after installation, keep bolts secure, and inspect the finish for wear if you perform frequent track runs. This accessory is intended for the TRF 415 chassis only.