Tamiya TRF 416 Upper Plate Graphite 416-07/WO by 3Racing  [416-07/WO]

Top deck purpose and fitment

This is a graphite top plate produced by 3Racing for the Tamiya TRF 416 chassis, listed as part 416-07/WO. It fits the TRF 416 as a direct replacement and does not require changes to the main chassis layout.

Because graphite is stiffer than typical composite tops, it alters load path between front and rear sections of the car. That usually results in a sharper steering response and a different mid-corner attitude, which drivers use to tune speed through bends on smooth on-road surfaces.

Installation is simple for those familiar with TRF maintenance: remove the original plate using the factory screws, verify that electronics clear the new deck, then secure the replacement using the original mounting points. Check clearances and hardware tightness, then run a short testing session to assess setup effects.