3RACING BS-501X/V1 Precision Bearings for Tamiya TRF 501X  [BS-501X/V1]

Tamiya TRF 501X Ball Bearing Set - 3RACING BS-501X/V1
Price:
NZD$34.54
Brand:
3Racing
Model:
BS-501X/V1
Condition:
Brand New
Write a review

Precision bearings tailored for the Tamiya TRF 501X

For drivers looking to tidy up drivetrain performance, the 3RACING BS-501X/V1 Ball Bearing Set replaces the standard bushings on the Tamiya TRF 501X. The result is reduced mechanical drag and steadier wheel spin.

What the 3RACING BS-501X/V1 brings to your kit

By cutting friction, ball bearings reduce heat and wear at rotating joints, improving consistency lap after lap. The BS-501X/V1 is produced to match TRF 501X dimensions so installation is straightforward and reliable.

Fitment advice and upkeep

Ensure bearings are inserted evenly and rotate freely after installation. Apply a small amount of suitable lubricant and clean debris from seals after runs in dusty or wet conditions to preserve life span.

Do I need special tools to fit these bearings?

A simple press or a socket that matches the bearing outer race works well. Avoid hammering directly on the inner race to prevent damage.

Are sealed bearings better for outdoor use?

Sealed bearings keep out grit and water but may run slightly hotter. Choose seals for wet or dusty conditions and open bearings if you need minimal friction for indoor racing.

How should I clean bearings after running?

Use a fast-evaporating solvent and spin the bearings to clear contaminants, then relubricate with a light oil before reassembly.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved