Tamiya TRF104 Battery Retainer Graphite Upgrade - Factory Pro O-TCPF09  [FP-O-TCPF09]

Price:
NZD$22.62
Brand:
Factory Pro
Model:
FP-O-TCPF09
Condition:
Brand New
Write a review

Graphite pack guard built for TRF104

This graphite pack guard is produced for the Tamiya TRF104 1/10-scale chassis and is supplied by Factory Pro as model O-TCPF09. It secures the battery in place while still allowing easy access for setup adjustments and rapid exchanges between runs.

Installation on the TRF104 follows a straightforward routine: remove the body, set the battery into the tray, line the guard up with the factory screw bosses and fasten using the existing screws. Tighten gradually to protect threads and confirm there is no interference with the motor, ESC or suspension before operating.

During tuning the guard ensures the battery sits in the same spot each time, helping to maintain consistent weight distribution and reducing unpredictable handling caused by a shifting pack.

How difficult is fitting this guard?

Fitting is basic for anyone familiar with the TRF104: remove the shell, place the pack, align and screw down. Expect a short bench session rather than a workshop job.

Can I move the battery position with this guard?

The guard is designed to lock the battery into the tray position. Any deliberate offset depends on the tray and existing mounting points, so changes may be limited.

Will the guard interfere with aftermarket parts?

Most common setups will fit without issue, but always check clearances against larger ESCs, motor mounts or custom wiring after installation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved