Tamiya TRF-416 Bridge Suspension Mount 3RACING 415-02 Track Upgrade  [415-02]

Tamiya TRF-416 Aluminium Bridge Suspension Mount - 3RACING 415-02
Price:
NZD$8.60
Brand:
3Racing
Model:
415-02
Condition:
Brand New
Write a review

Bridge Suspension Mount 3RACING 415-02 for Tamiya TRF-416

The 3Racing aluminium bridge suspension mount is built to firm up the Tamiya TRF-416 chassis and reduce unwanted flex. The upgrade helps the car hold a more constant line through mid and high speed corners.

Stability and Strength Gains

This aluminium part gives greater resistance to bending than stock plastic mounts, which helps preserve suspension geometry during heavy loads. That stability makes it easier to tune for predictable turn-in and exit.

Direct Fit to TRF-416 Points

Manufactured to suit the Tamiya TRF-416 mounting pattern, the 3RACING 415-02 drops in with minimal fuss. It is a good choice for replacing tired mounts or for drivers wanting a reliable, low fuss upgrade.

Tips for a Clean Installation

Use the original mounting hardware where possible and torque screws evenly. After installation, recheck alignment under the car and run a short test to confirm handling feels balanced.

If the arm mounting positions remain unchanged the 3RACING 415-02 should fit. Significant layout changes may require adjustments or alternate hardware.
The mount itself does not change ride height, but the added stiffness can shift handling balance; minor shock tuning may be needed to match your setup.
Light thread locking on metal-to-metal joints is optional depending on your hardware and driving style. Check screws after the first run and periodically thereafter.
The aluminium mount adds some mass compared to plastic, but the tradeoff is increased rigidity and longer service life, which many drivers prefer for track consistency.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved