Tamiya TRF421X Replacement Graphite Main Chassis 2.25 O-TCP009 by Factory Pro  [FP-O-TCP009]

Factory Pro FP-O-TCP009 Tamiya TRF421X - Main Chassis - Graphite 2.25
Price:
NZD$78.89
Brand:
Factory Pro
Model:
FP-O-TCP009
Condition:
Brand New
Write a review

Overview: Graphite Plate for TRF421X

The Factory Pro O-TCP009 is an aftermarket graphite main chassis made for the Tamiya TRF421X vehicle. It offers a direct-fit graphite plate that mirrors the TRF421X mounting pattern and supports typical chassis layouts used on that platform.

Intended for chassis setup work, the graphite plate alters flex behavior and driver feedback when you tune suspension or roll centres. During installation, check hole alignment with TRF421X parts and reuse original hardware where appropriate. Confirm clearance near the motor mount, gearbox, and bulkheads before finishing assembly.

Specifications

  • Item Main Chassis
  • Material Graphite
  • Model Number O-TCP009
  • Compatibility Tamiya TRF421X
  • Size 2.25

Select the Factory Pro graphite main chassis O-TCP009 when you require a like-for-like TRF421X replacement or when fine-tuning chassis balance and flex is part of your setup strategy; always verify fit and torque settings to maintain alignment.

Is the O-TCP009 robust enough for regular club racing?

The graphite plate is intended for performance use but inspect it regularly for impact damage; proper mounting and correct torque prevent premature stress in graphite components.

How should I check for stress or cracking?

After heavy impacts, visually inspect mounting faces and edges for hairline cracks and run your fingernail along joints; replace the plate if you detect delamination or edge fractures.

Will this graphite plate change ride feel on small bumps?

Yes. Graphite shifts flex characteristics so you may notice different feedback over small undulations; compensate with shock and anti-roll tuning to retain desired balance.

Are additional fasteners recommended for longevity?

Use quality screws and check threads before reuse. If original hardware shows wear, replace with correct-size fasteners to avoid concentrated stress points in the graphite.

Can I sand or modify the plate edges?

Minor edge dressing is possible to remove burrs, but avoid deep cuts that alter thickness or create stress risers; keep modifications minimal and even.

Should I change setup after installing this plate?

Expect some change in chassis feedback; re-evaluate spring rates, ride height, and roll balance after fitting the Factory Pro O-TCP009 to dial in handling.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved