Tamiya TT-01 Rear Aluminium Hub Carrier 0 Degree - TT01-12/0/LB by 3Racing  [TT01-12/0/LB]

Tamiya TT-01 /TT-01 TYPE E Rear Aluminum Hub Carrier (0 Degree) - 3Racing TT01-12/0/LB
Price:
NZD$19.29
Brand:
3Racing
Model:
TT01-12/0/LB
Condition:
Brand New
Write a review

Rear Aluminium Hub Carrier for TT-01 Fitment

This rear hub carrier is an aluminium replacement made to suit Tamiya TT-01 and TT-01 TYPE E chassis configurations, sold under part number TT01-12/0/LB by 3Racing.

Installation follows the familiar TT-01 routine: detach the rear knuckle assembly, swap in the aluminium unit, and refit using the existing wheel axle and mounting screws. Check part alignment during reassembly and use common hex drivers to complete the job.

From a setup angle, swapping to a metal carrier stabilises the rear knuckle mount and can affect suspension feedback. Use this component when you need more durable mounting points or when adjusting rear toe and camber experiments; correct bearing choice and wheel offset will help retain the intended handling balance.

Is this compatible with aftermarket TT-01 uprated parts?

Compatibility depends on the specific uprated item; most direct-replacement rear knuckles follow stock mounting dimensions, but check clearances with your parts first.

Are threadlock or loctite recommended on the screws?

Light use of a medium-strength threadlocker is fine for metal-to-metal locations, but avoid over-tightening which can distort alignment.

Should I change spring or damper rates after fitting this part?

You may want to fine-tune damping or springs if you notice increased stiffness at the rear; small adjustments can help recover the original balance after fitting a metal carrier.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved