Tamiya TT-01 Rear Hub Carrier Machined Aluminium 2 Degree TT01-12/2/LB by 3Racing  [TT01-12/2/LB]

Rear hub carrier designed for TT-01 platforms

This machined aluminium rear hub carrier is supplied as a scale replacement for Tamiya TT-01 and TT-01 TYPE E chassis. It delivers a fixed 2 degree rear hub angle to influence rear toe and roll behaviour on electric touring and scale models.

Built from machined aluminium for improved dimensional stability versus the stock plastic carrier, the part fits the same mounting location used on compatible TT-01 assemblies. Use this carrier when you require a metal baseline for handling adjustments or when replacing old plastic parts.

Installation notes: fit the carrier in place of the original rear hub carrier using the existing TT-01 mounting points. After fitting, confirm wheel alignment and rear toe and check clearances across suspension travel. This product is intended purely as an aftermarket handling and setup component.

Compatibility notes

Compatible with Tamiya TT-01 and TT-01 TYPE E chassis as an aftermarket replacement part.