Tamiya TT-01 Rear 3 Degree Hub Carrier by 3Racing TT01-12/3/LB  [TT01-12/3/LB]

Sharper Cornering for TT-01 with the 3Racing TT01-12/3/LB Rear Hub

For hobbyists wanting crisper handling, the 3Racing Tamiya TT-01 / TT-01 TYPE E Rear Aluminum Hub Carrier gives a fixed 3 degree toe-in that helps settle the rear through turns. Built from aluminium for a good balance of lightness and strength, it is suited to frequent club racing and practice sessions.

Performance Gains from the Aluminium Carrier

The 3 degree setting improves rear grip and directional stability, which helps during acceleration out of corners. Aluminium resists deformation under load so the part keeps its geometry race after race.

Compatibility and Fitment Advice

This hub carrier is compatible with both TT-01 and TT-01 TYPE E platforms. Installation is straightforward, but a quick alignment check and trial runs will let you dial in the final toe settings for your track conditions.