TAMIYA TT01E/TT01ED Aluminium Front Upright Knuckle Arms Precision Upgrade - JR-TT101-BK by Jazrider  [JR-TT101-BK]

Tamiya TT01E / TT01ED Aluminum Front Upright Knuckle Arms (Black)
Price:
NZD$19.45
Brand:
JAZRIDER
Model:
JR-TT101-BK
Condition:
Brand New
Write a review

Direct-fit front upright replacement for TT01E/TT01ED

This component is produced as a direct replacement for the TAMIYA TT01E and TT01ED front upright knuckle arms, finished in black anodized aluminium and assigned model JR-TT101-BK. It is intended to use the same mounting points so no chassis modification is required when fitment is correct.

Practical notes: swapping out plastic uprights for aluminum increases the stiffness of the steering mount, which helps limit deformation at the hub and makes setup changes more consistent during tuning sessions.

Fitment advice: confirm that screw positions, thread engagement, and bearing inner diameters match your existing TT01E/TT01ED parts before tightening. No supplementary parts list is included here.

What steps should I follow to install these uprights?

Remove the original knuckles, inspect bearings and screw lengths, then fit the aluminium arms in the same orientation; hand-start screws before final torque to ensure correct seating.

Are special tools required for installation?

Standard hobby tools are usually sufficient; a torque-limited driver is useful to avoid over-tightening into aluminium threads or compressing bearings.

How can I confirm correct bearing fitment?

Ensure bearings press flush without play and that axle shafts rotate freely; if a bearing sits proud or binds, check bore sizes and replace hardware as needed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved