Tamiya TT01/TT01E Front Upper Arms Upgrade (Aluminium, Light Blue) - JR-TT104-LB by Jazrider  [JR-TT104-LB]

Tamiya TT01 / TT01E Aluminum Front Upper Suspension Arms (Light Blue)
Price:
NZD$17.51
Brand:
JAZRIDER
Model:
JR-TT104-LB
Condition:
Brand New
Available in shop
Write a review

Anodised Light-Blue Upper Arms for TT01/TT01E

Designed as an aftermarket aluminium upgrade for the Tamiya TT01 and TT01E, this set replaces the stock plastic front upper arms and is finished in light blue anodizing. The components are machined from aluminium to provide increased rigidity at the front end.

Fitting aluminium upper arms will change front-end stiffness and thus influence roll and camber reactions during driving. They are made to fit the TT01/TT01E front suspension geometry and are useful when fine-tuning steering feedback and corner behaviour.

Installation uses the chassis' existing arm mounting points and typical TT01-series hardware. Trial-fit the arms on your specific variant, then confirm and adjust suspension geometry after final assembly.

Do I need new screws or spacers to fit these arms?

In most cases the arms use the standard TT01-series mounting hardware. Inspect existing screws and spacers for wear and replace only if they are damaged or do not seat correctly.

Are special tools required for installation?

No special machining is required; common RC hand tools such as hex drivers and pliers are sufficient. Work carefully and tighten hardware to normal setup torque levels.

Will these arms change ride height?

The arms themselves do not alter static ride height, but the change in stiffness can affect camber and handling; check and adjust ride and alignment after fitting.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved