TAMIYA TT-02 Drive Shaft Set (Aluminum + Steel Joint) - TT02-13100_13115-LB by Jazrider  [TT02-13100_13115-LB]

Tamiya TT-02 Aluminum Main Shaft with Steel Joint Set
Price:
NZD$16.28
Brand:
JAZRIDER
Model:
TT02-13100_13115-LB
Condition:
Brand New
Available in shop
Write a review

Reinforced Drive Shaft for TT-02

The TT02-13100_13115-LB replacement assembly fits the TAMIYA TT-02 1/10 scale chassis and pairs an aluminium main shaft with a steel joint to limit wear where the shaft meets drive components and to provide a firmer coupling than stock plastic pieces.

Used as a cost-effective reinforcement inside the gearbox area, this part helps stabilise the drivetrain under heavier loads from upgraded motors or more assertive driving. The component comes in light blue and is intended for scale RC use only.

Installation is a like-for-like swap for the original TT-02 shaft and joint. This upgrade focuses on fit and alignment rather than altering gear ratios, so you should expect durability improvements and less flex rather than changes to top speed or gearing.

Will this reduce the frequency of drivetrain failures?

Yes, by replacing the softer plastic parts with an aluminium shaft and steel joint you lower the chance of deformation and wear under sustained loads, which helps reduce failures in the gearbox area.

Do I need to modify other parts when fitting this shaft?

No major modifications are expected; it is designed as a direct replacement. Still, check mating surfaces and fasteners and make small clearance checks to ensure smooth rotation after fitting.

Is the light blue finish purely cosmetic?

Yes, the light blue finish is an aesthetic coating and does not alter mechanical compatibility. Confirm fitment for your specific TT-02 variant prior to installation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved