TAMIYA TT-02 Front and Rear Main Propeller Shaft Bearing Mounts TT02-13124-LB by Jazrider  [TT02-13124-LB]

Tamiya TT-02 Aluminum Front & Rear Main Propeller Shaft Bearing Holder Set
Price:
NZD$12.57
Brand:
JAZRIDER
Model:
TT02-13124-LB
Condition:
Brand New
Available in shop
Write a review

TT-02 Front/Rear Shaft Bearing Brackets

This set supplies aluminium bearing brackets for the front and rear propeller shaft positions on the Tamiya TT-02 chassis. They create a stiffer bearing location which helps hold alignment during setup and routine checks.

Intended for hobbyists performing chassis tuning, the brackets decrease lateral play in the main prop shafts and make bearing removal and placement more straightforward. Installation assumes familiarity with disassembling small drivetrain sections.

Fitment tips: ensure bearings seat smoothly without force, align shafts before tightening, and verify there is no contact with nearby gearbox housings or suspension linkages. The mounts aid in consistent setup when adjusting shaft-related geometry.

Will these holders stand up to regular club running?

Yes, the aluminium construction increases rigidity compared with stock plastic mounts, but inspect fastenings and bearing seats periodically to catch loosening or wear early.

Are any special lubricants recommended for bearings used with these mounts?

Standard light bearing oil or grease suitable for RC wheel bearings is fine. Avoid heavy greases that can attract debris into the bearing seat area.

Do these brackets need periodic adjustment after initial fit?

Check alignment and fastener tightness after the first few runs and then at regular service intervals; aluminium can transmit vibration differently than plastic so small retorques are normal.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved