Tamiya TT02 Rear Bumper Foam with Fibre Plate TT2200R by GPM  [TT2200R]

Urethane rear bumper for TT02

This aftermarket rear bumper has been developed for the Tamiya TT02 platform and is listed as model TT2200R. It combines a urethane foam impact element with a fibre plate backer to offer a light but effective rear bumper for hobby TT02 rigs.

The part functions as a rear impact pad and helps locate the body on the chassis. Urethane foam gives controlled compression on impact while the fibre plate keeps the bumper seated and resists flex under load. It is intended for RC hobby use and sized for TT02 variants.

Fitting is simple on common TT02 setups: align the fibre plate to rear mounting points and reuse the stock bumper screws. Check body alignment and rear suspension movement before tightening hardware fully.

For setup, the softer foam contact can reduce bounce compared with hard bumpers and lower the chance of damaging rear body posts during light collisions. Monitor the foam for wear and swap it out once it no longer springs back.