Tamiya TT02B 95mm Adjustable Rear Shock Alloy TT2B095R by GPM  [TT2B095R]

Rear alloy shock tailored to TT02B geometry

This rear spring damper is a direct-fit 1:10-scale aftermarket replacement for the Tamiya TT02B chassis. Constructed from aluminum alloy with a threaded preload collar, it lets you change spring preload and static ride height without altering the shock tower; the pair is built to match the TT02B rear mounting layout.

Installation follows standard shock replacement steps: remove the original rear shocks, swap or fit springs as required, secure the alloy dampers to the lower and upper mounts, then confirm full travel and droop limits. No special equipment is necessary beyond routine hex drivers and shock pliers, and the collar allows trackside adjustment of rebound bias and rear height.

For setup, focus on balancing spring preload and damping rather than chasing progressive effects. Incremental collar changes shift rear ride height and influence weight transfer on corner exit and acceleration. Pair these with suitable front shocks and springs to maintain consistent handling for timed runs or club sessions.

If you need a robust, adjustable rear unit that fits TT02B mounting points, this 95mm alloy set provides accessible tuning of rear ride height and handling balance for hobby and club use.