Tamiya TT-02B Aluminum Rear Shock Tower Stay JR-TT2B07-RD by Jazrider  [JR-TT2B07-RD]

TT-02B shock tower reinforcement, red anodized

The JR-TT2B07-RD rear damper stay is manufactured in anodized red aluminum and shaped to match Tamiya TT-02B mounting points. As a direct replacement for the plastic stay, it increases the rigidity of the rear shock mount without altering ride geometry.

Design purpose: This component is intended to reduce chassis flex at the rear shock tower under load, which helps maintain repeatable shock angles when adjusting suspension settings or running on varied surfaces. It supports more predictable tuning rather than adding raw power.

Fitting advice: Install using the TT-02B's original rear tower screw locations and reuse hardware if it seats correctly. Inspect threads and confirm proper engagement before final torque, then verify after initial track time. Typical RC maintenance tools are sufficient for fitting.