TAMIYA TT-02B Precision Aluminum Conversion Kit for Reduced Flex - JR-TT2BCK-LB by Jazrider  [JR-TT2BCK-LB]

Durable anodized aluminum conversion for TT-02B

This aluminum conversion upgrade replaces specific plastic mounting points on the TAMIYA TT-02B with blue anodized aluminum parts to create a tougher interface for suspension and drivetrain fixings. The anodized finish helps resist wear where metal components meet and supports longer-term dimensional stability under repeated use.

Confirm your chassis is the TT-02B before fitting as the kit is tailored to that layout. Fitting is straightforward: remove the stock plastic pieces and fasten the aluminum parts using the original screw holes. Standard hex drivers are sufficient; attention to thread engagement and the selective use of thread locker is advised for race or high-vibration scenarios.

Inspection and upkeep are minimal—check torques after initial installation and again after running, and examine anodizing where hardware contacts may abrade the surface. These components are intended to stabilise mounting geometry rather than to deliver outright power improvements, so pairing with complementary setup parts delivers the most noticeable handling gains.

Best suited to modelers and club racers seeking a more robust mounting platform on the TT-02B chassis to support consistent setup and reduce maintenance cycles.