TAMIYA TT-02B/DF-02 Compatible Front Knuckle Arms, Aluminium - JR-TT2B01-BK by Jazrider  [JR-TT2B01-BK]

Overview: aluminium knuckle arms for TT-02B and DF-02

The JR-TT2B01-BK knuckle arm set is an aluminium steering component built for TAMIYA TT-02B and DF-02 chassis platforms. Finished in black, these machined parts replace the softer plastic knuckles to raise rigidity at the steering link and hub interfaces, improving repeatable geometry during cornering.

Fitting is intended for modellers comfortable with front-end servicing. Remove the factory knuckles from the hub carriers, transfer wheel hub pins, e-clips, bearings and shims as required, and fit the aluminium arms. Double-check steering link clearances and full suspension articulation once fitted. Standard hex drivers and hand tools are sufficient.

Compared to stock plastic arms, aluminium alternatives resist deformation and hold alignment under load, which benefits setup tuning for lap-to-lap consistency. Keep an eye on fasteners during the first outings and re-torque hardware as needed.