Tamiya TT02/TT02B Aluminium Steering Upgrade TT2B048 by GPM  [TT2B048]

Aluminium steering replacement for TT02 platforms

This aluminium steering assembly is an RC-scale replacement part for Tamiya TT02 and TT02B touring chassis. It replaces the stock plastic steering components with metal parts to stiffen the linkage and pick-up points, cutting down on flex and improving steering precision when you drive hard through corners.

Fitting is primarily a swap of the factory steering hardware and does not require servo reprogramming. Basic tools like hex drivers are needed, and you should re-check steering geometry after installation; tighten all fasteners to the correct engagement and ensure neutral toe and correct Ackermann before use. The part works with common 1/10 touring setups and standard servo sizes on TT02 cars.

Tuning advice: use this aluminium assembly if you want a firmer mechanical foundation for steering tweaks or when pairing with stronger servo horns or reinforced tie rods. It does not change electronic parameters but helps make mechanical adjustments more repeatable.