This alloy damper mount serves as a replacement part for the Tamiya Wild Dagger chassis and is intended for use in both front and rear suspension positions.
Produced in alloy to increase stiffness over standard plastic mounts, the component includes collars and screws to assist accurate fitting and secure damper assemblies. It is supplied as a 1pcs set for the stated mounting point.
During setup the alloy mount reduces movement at the shock eye under load, which helps preserve consistent rebound and compression when you change spring rates, fluid viscosity, or shock positions. Fitting requires basic shock tower access and standard thread tightening of the supplied fasteners.
Use this alloy mount where improved mounting stiffness and dependable fastener retention are important for accurate damper setup.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
