Tamiya Wild Willy 2 WR-02 Rear Upper Link Spring Steel WW2057S by GPM  [WW2057S]

Overview of rear top link

Designed as a spring steel aftermarket link, this rear upper tie rod fits the Tamiya Wild Willy 2 WR-02 chassis and is supplied as a pair labelled WW2057S. It functions as an RC-scale link that mounts at the rear upper connection between hub or knuckle assemblies and the WR-02 link points.

Fit and function: intended to replace aged or factory plastic links, the steel rod restores suspension geometry and provides a firmer rear link that reduces flex. This direct-replacement piece is suited to the WR-02 rear upper position and helps keep wheel alignment under load or when running heavier equipment.

Installation notes: remove the old rear upper rod and swap over ball ends or linkage fittings. The WR-02's original fasteners and pins should be reused; check that threads engage correctly and that ball studs are tightened to a secure but free-moving point.

Care and tuning role: spring steel resists permanent bend more effectively than typical plastic links, offering a more predictable rear end for drivers tuning for sharper response. Inspect ball ends periodically and ensure pivot points are clean and lightly lubricated to extend service life.