Black JAZRIDER JR-WR101-BK Aluminium Shock Tower - Front/Rear Fit for Tamiya WR01 WT01 (1pc)  [JR-WR101-BK]

Tamiya WR01/WT01 Aluminum Front/Rear Shock Tower (1pc)(Black)
Price:
NZD$11.87
Brand:
JAZRIDER
Model:
JR-WR101-BK
Condition:
Brand New
Available in warehouse
Write a review

Upgrade your Tamiya WR01/WT01 with the JAZRIDER aluminium tower

The JAZRIDER Aluminium Front/Rear Shock Tower JR-WR101-BK gives Tamiya WR01 and WT01 cars a solid upgrade path. The alloy construction reduces unwanted flex, delivering more consistent suspension behaviour across varied surfaces.

Why pick aluminium for the tower?

Aluminium is chosen for its mix of stiffness and low mass. Swapping to an alloy shock tower helps the suspension keep its alignment under load, which improves predictability during aggressive driving and on broken ground.

Compatibility notes and quick fit

Made to match Tamiya WR01 and WT01 mounting points exactly, the JR-WR101-BK installs without modification. Typical RC tools are enough to complete the swap in minutes so you can get back to running lines and testing setups.

Can I use this on a tuned suspension setup?

Yes. The JR-WR101-BK supports tuned setups and helps preserve the geometry under higher spring or damper loads.

Is this part heavier than the stock plastic tower?

It is typically heavier than plastic but designed to balance added strength with modest weight increase, improving handling without significant penalty.

Any special care needed for the alloy?

Keep bolts torqued to RC practice levels and check fasteners after initial runs. Cleaning off grit and applying light anti-seize to threads prevents corrosion.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved