Tamiya WR02/DT03T/Blitzer Beetle Stiff Front Upright Set - JR-WR201-BK by Jazrider  [JR-WR201-BK]

Tamiya WR02/DT03T/Blitzer Beetle Aluminum Front Upright Set (Black)
Price:
NZD$15.42
Brand:
JAZRIDER
Model:
JR-WR201-BK
Condition:
Brand New
Available in shop
Write a review

Heavy duty upright fit notes

This upgrade replaces stock plastic uprights on Tamiya WR02, DT03T and Blitzer Beetle with machined aluminum pieces to reduce flex at the steering knuckle and improve durability under repetitive loads. The firmer construction helps maintain consistent steering geometry during rough runs and repeated impacts.

Fitting follows the normal upright replacement steps: remove the wheel hub assembly, swap in the new uprights using existing bearings and retaining hardware, then check alignment and steering movement. No specialized tools are required beyond standard hex drivers and pliers common to Tamiya maintenance.

From a durability standpoint, these uprights are suited to drivers who push their rigs hard or frequently run on abrasive surfaces. Pairing with tougher bushings and periodic hardware checks will maximize longevity.

Compatibility

  • WR02
  • DT03T
  • Blitzer Beetle

Are these uprights less likely to crack than stock plastic parts?

Yes. The aluminum construction resists cracking and deformation better than stock plastic, especially under repeated high-load impacts, though it can transfer more shock into surrounding components so check adjoining parts regularly.

Will anodizing or finish affect wear?

Surface finish can reduce corrosion and minor abrasion, but wear at bearing contact points depends mostly on fitment and maintenance. Keep bearings clean and lubricated for best life.

Do hardened uprights change stress on related suspension parts?

Stiffer uprights can shift load to ball joints, hinge pins and steering links; inspect those items more often and replace any fatigued parts to avoid premature failure.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved