Tamiya WT-01N Steering Tie Rod Assembly WTN160 by GPM  [WTN160]

Tamiya WT-01N Aluminium Completed Tie Rod - 1set - GPM WTN160
Price:
NZD$22.11
Brand:
GPM
Model:
WTN160
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Finished aluminium tie rod for WT-01N chassis

The GPM WTN160 is supplied as a completed aluminium tie rod assembly tailored to the Tamiya WT-01N chassis, ready to replace worn steering links. The alloy construction provides a firmer connection between the radio servo and steering knuckles on 1/10 monster truck models using the WT-01N platform.

Installation is beginner-friendly for those used to basic steering servicing: detach the stock tie rod ends, mount the completed aluminium unit to your existing ball cups or rod ends, then confirm neutral steering and wheel alignment before use. Inspect thread engagement and hand-tighten fasteners to the recommended hobby torque to protect steering components.

Is this WTN160 tie rod an OEM part?

This is an aftermarket aluminium replacement produced for the WT-01N chassis; it is not an original equipment part from the chassis manufacturer.

Any prep needed before fitting?

Check the length and thread pitch against the stock parts, clean mating surfaces, and ensure ball cups or rod ends slide freely before final tightening.

Should I use thread lock on fasteners?

Light application of a removable thread locker on metal-to-metal fasteners is fine for most hobby setups; avoid permanent thread lock if you expect to adjust tie rod length frequently.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved