This aluminium steering assembly is supplied as one set and is made to fit the Tamiya TB-04 steering locations. It replaces the standard plastic links to cut flex and improve the mechanical interface between the servo and steering knuckles.
Installation guidance: install the kit using the chassis screw points and original link geometry; no additional drilling or chassis changes should be needed. After fitting, check steering travel, verify front wheel alignment and tighten fasteners evenly to prevent binding. Use of compatible bearings and TB-04 servo link hardware is expected.
Tuning notes: the aluminium linkage acts as a firm direct replacement that stabilises steering geometry for fine adjustments. It is useful when dialing in ackermann, toe settings and steering sensitivity on TB-04 models.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
