TB-05 PRO Rear Damper Stay Mount Tamiya 54905 TB-05 OP-1905 - Aluminium Upgrade  [54905]

Tamiya 54905 - TB-05 Aluminum Rear R Damper Stay Mount OP-1905
Price:
NZD$30.75
Brand:
Tamiya
Model:
54905
GTIN:
4950344549054
Condition:
Brand New
Available in warehouse
Write a review

Improve Rear Rigidity on the TB-05 PRO

The Tamiya 54905 aluminium rear damper stay mount upgrades the TB-05 PRO by replacing the flexible plastic part with a stiffer aluminium mounting point. The result is a firmer rear end that responds better to suspension tuning.

Durability Meets Tuning Accuracy

Constructed from durable aluminium, this damper stay mount reduces flex under load and holds setup settings more consistently than the stock plastic equivalent. The blue anodised coating helps protect the surface from everyday wear while keeping a neat factory look.

Compatibility and Fitment Notes

This component is intended for the TB-05 PRO chassis and fits using the original mounting positions. It offers a straightforward swap for enthusiasts wanting a durable spare part that supports precise adjustments.

Can I run this on a competition TB-05 setup?

Yes, the aluminium stay mount is aimed at performance setups where reduced flex and repeatable geometry are needed for consistent lap times.

Is any trimming required for installation?

No trimming is typically required. The part is made for a direct fit to TB-05 PRO chassis mounting points. Verify screw lengths to avoid thread damage.

Will this change handling feel immediately?

You should notice crisper rear response when making suspension adjustments, especially under cornering load. Small setup changes become more predictable with the stiffer mount.

How should I care for the aluminium part?

Wipe down after dusty or wet runs and check mounting screws for tightness. The anodise is protective but regular checks prevent loosening from vibration.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved