3Racing MRC-10/BU Aluminium Gear Dust Cover - Mini-Rock Crawler Upgrade  [MRC-10/BU]

Team Losi Mini-Rock Crawler Aluminum Gear Dust Cover - 3RACING MRC-10/BU
Price:
NZD$0.00
Brand:
3Racing
Model:
MRC-10/BU
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Team Losi - Mini-Rock Crawler category
Write a review

Keep drivetrain debris-free with a solid aluminium cover

Hobbyists looking to cut down on gearbox servicing will appreciate the 3Racing Aluminum Gear Dust Cover for the Team Losi Mini-Rock Crawler. The aluminium plate shields gears from dust and small stones that can accelerate wear.

Precision fit and resilient finish

Built to sit flush with the crawler's chassis, this cover provides consistent protection without fouling linkages. The anodised aluminium resists scuffs and keeps the unit looking tidy after frequent use.

Quick bolt-on installation

Installation uses the existing screw points and does not require permanent changes to your vehicle. The straightforward fitment means you can upgrade quickly and get back on the trails.

Can I run this cover in wet or sandy conditions?

Yes, the aluminium barrier reduces ingress of water and sand, but routine checks and drying are recommended after severe conditions to prevent corrosion of fasteners.

Will motor or servo clearances be affected?

The design respects factory clearances for the Mini-Rock Crawler; confirm component placement if you use non-standard electronics.

Are replacement screws included or sold separately?

Hardware policies vary by retailer; check the product listing to see whether mounting screws are supplied or need to be sourced separately.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved