Team Powers 23T 64P Hard-Coated Pinion Gear PG6423  [TP-PG6423]

Team Powers 23T Hard-Coated 64P Pinion Gear
Price:
NZD$9.46
Brand:
Team Powers
Model:
TP-PG6423
Condition:
Brand New
Write a review

Rugged Performance from Team Powers 23T

The Team Powers 23T Hard-Coated 64P Pinion Gear, model PG6423, is a practical upgrade for RC motors that need durable gearing. Precision-cut teeth and a protective hard coat help reduce wear while maintaining smooth torque transfer.

Why the Hard Coat Matters

Hard-coating slows down the inevitable wear on pinion teeth, extending the life of the gear in repeated sessions. The smoother tooth finish also helps cut down on friction, preserving motor efficiency and reducing heat build-up.

Compatibility Notes and Uses

Built for 64P systems, this 23T pinion suits a wide array of motor and spur combinations in 1/10 scale cars. Its broad compatibility makes it suitable for casual builders as well as more serious club racers aiming for reliable drivetrain parts.

Can I use this with brushless motors?

Yes, the PG6423 works with both brushed and brushless motors that accept 64P pinions, provided the shaft and set screw match your motor.

How should I check gear mesh after fitting?

Fit the pinion, rotate the drivetrain, and use a thin pencil lead or feeler to confirm a small clearance between pinion and spur. Re-adjust until noise and binding are minimal.

Does the coating affect sharpening or dressing the gear?

The hard coat is not intended for reshaping; if teeth show wear, replace the pinion rather than attempting to dress the coating, which can damage tooth geometry.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved