Team Powers TP-BLM-SW80-M Gold Connector Sensor Lead 80mm  [TP-BLM-SW80-M]

Price:
NZD$11.06
Brand:
Team Powers
Model:
TP-BLM-SW80-M
Condition:
Brand New
Write a review

Reliable Sensor Lead for Miniz: Team Powers TP-BLM-SW80-M

RC enthusiasts working on Miniz platforms can use the Team Powers 80mm Sensor Wire with a golden connector to tighten motor control. The cable is aimed at keeping signal lines stable between the ESC and motor during demanding use.

Designed for Compact Miniz Installations

The Team Powers sensor wire is tailored for Miniz fitments and installs without fuss. At 80mm, it offers enough slack for neat routing, and the gold connector reduces contact resistance and the chance of corrosion.

Practical Advantages for Hobby Use

This sensor lead supports consistent motor timing and helps prevent intermittent signal loss that can upset driveability. It is a straightforward upgrade for racers and club drivers who want dependable performance from their Miniz.

Is the TP-BLM-SW80-M plug ready to use out of the box?

Yes, the sensor wire arrives ready to install without soldering on the connector, making it quick to fit on most Miniz motors and ESCs.

Can I trim the wire length if needed?

You can shorten the cable if required, but avoid cutting too close to the connector and ensure any retermination is done with suitable connectors to keep signal quality.

How should I maintain the gold connector?

Keep the connector free of dirt and moisture; a quick wipe with a clean cloth after runs is usually enough to preserve good contact.

Will this wire add noticeable weight to my Miniz?

The TP-BLM-SW80-M is very lightweight and the small increase in mass has negligible effect on handling while giving more reliable sensor feedback.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved