Team Powers XT60 500mm 12AWG XT60 to 4mm Bullet Lead  [TP-PC-XT60]

Team Powers XT60 Power Cord (12AWG wire, 500mm length , 4mm bullets) (TP-PC-XT60)
Price:
NZD$16.87
Brand:
Team Powers
Model:
TP-PC-XT60
Condition:
Brand New
Write a review

Compact High-Current Lead for RCs

Team Powers XT60 Power Cord is a compact solution for connecting packs and chargers without excess bulk. Its 12AWG wire and 500mm length are chosen to keep resistance down while remaining easy to route around your workspace.

Connector and Wire Details

The cord combines an XT60 plug with 4mm bullet connectors to support common battery and accessory hookups. The heavier 12AWG conductor helps deliver steady current under load, reducing heat buildup in frequent use.

When to Use This Lead

Use this 500mm lead when you need a tidy connection between a battery and charger or for bench testing. Team Powers XT60 fitment is versatile and works well in most hobby charging stations.

Is polarity marked on the connectors?

XT60 housings are keyed and usually have polarity markings; still verify positive and negative before connecting to avoid reverse polarity damage.

Are the 4mm bullets a common size for motors and ESCs?

4mm bullets are widely used for motor and ESC leads in many RC models, making this cord handy for adapting between battery and powertrain components.

Can I crimp or should I solder the bullet connectors?

Crimping can be fine if done with the right tools, but soldered joints tend to give the most reliable electrical contact for high current applications.

Is the 500mm length too long for small models?

For very tight builds you might trim the lead, but 500mm is a practical compromise for bench use and many in-vehicle setups. Keep routing tidy to prevent snagging.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved